Every girl loves a crown. Flower crowns are the must have accessory of 2013. Don’t just wear them to weddings, slip one on whilst popping out for your weekly shop, glam up any evening dress with this floral DIY post.

Invest in a good pair of scissors. We always use these yellow handled beauties – perfect for cutting stems and wires alike.

We’ve suggested using 3 different wires. One thicker wire which you will wrap around your head to get the correct measurements and 2 different wires for your flowers.

Parafilm will become your new best friend – pop it down your top until you are ready to use it. This will get it nice and warm, making it super flexible and stopping it from snapping every time you pull it tight.

There are loads of different ways you can make a floral crown. In this DIY tutorial we will show you the method where you will bind the flowers onto a metal hair band. Its a little less fiddly than the other methods, and is also a lot quicker allowing you to knock up a floral crown 10 minutes before your guests arrive.

So first off get a long length of your thicker wire and wrap it around your head where you would like your finished crown to fit. At the ends you want to make some loops which you can use to pin the crown to your head for some added security. I like to tie ribbons into these loops too for a little detailing at the back of my head.

Wiring the flowers! This is where the fun starts…

We’ve chosen to use lots of different flowers in our crown including; carnations, waxflower, calendula, mini daisies and little spray roses. You can pretty much use anything, although some things may wilt a little quicker than others.

For most stems the wiring methods shown in the above diagrams will see you through. For thicker stems where you can pierce the wire through the base of the flower (carnations, roses etc) I would suggest using fig. 1 – 3. If you’ve got a thinner stem like waxflower or the mini daisies you want to create a little U shape and wrap the wire against itself see fig. 4-6 for our how to.

After you’ve neatly wired each flower you want to cover the stems in the parafilm. Pull it tight, almost to breaking point and twizzle your stem or wire to wrap it around.

Start wrapping you parafilmed wires around your wire headband. Layer each flower overlapping the next. I love a statement piece … go big or go home!

One floral crown ready and raring to go!

Send us a snap of your floral crown outings … pretty please!

2 thoughts on “Friday Treats … Floral Crown DIY Tutorial

  1. Hannah says:

    This is a fun DIY project, I love the natural styling for brides.
    A wedding I photographed a couple of weeks ago had your flowers, really stunning bouquets and the succulent button holes were perfect for their modern feel.

Leave a Reply